Owner`s manual
ELECTRICAL HAZARD
To avoid accidental contact with lawn mowers and hedge ....................
trimmers, power cords should remain within sight and above ground at all times.
The Clearwater Ei Power pack must not come into contact with pool water and
should be installed at least 3 metres from the inside wall of your swimming pool.
Should a lack of water ow be detected, the unit’s electronic ow switch is designed
to turn off the system. Interfering with the electronic ow switch could result in
personal injury and/or damage to the cell.
One pump per electrical socket only (no ancillary equipment should be connected to
the same outlet).
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
The installation of the chlorinator should be carried out by a qualied pool
professional. Please contact our customer care helpline on 0860 963422 for your
nearest pool professional.
3
18
24 HOUR SAFETY
TIMEOUT
To prevent the possibility of hazardous over-chlorination, the Clearwater Ei unit
has a built-in safety shutdown. If the Clearwater Ei salt chlorinator is manually turned
ON (with no timers set), and left on, chlorine generation will automatically turn OFF
after 24 hours. The Clearwater Ei salt chlorinator can be turned ON as normal after
this time.
NOTE: If using the Clearwater Ei unit with an external timer – the
24 hour timer is reset whenever power is cut to the Clearwater Ei
unit.
CHLORINATOR REVERSAL
The Clearwater Ei salt chlorinator has a reverse polarity cell. This means that every
5 hours the cell will switch its polarity to help prevent any build up of calcium on
the cell plates. This is sometimes referred to as self cleaning. During the transition
between changing its polarity there is a 5 minute wait time when the cell will not
produce any chlorine. Don’t be alarmed, once it has changed polarity it will continue
producing chlorine.
‘** CLEANING **’ will be displayed on the screen during the 5 minute ‘WAIT’ period.
(The output level indicator will remain as set during the CLEANING period).