Owner`s manual

13) Position the locking ring with the
alignment details as shown, before threading.
14) Screw down the locking ring to the
threaded housing, ensuring it’s level.
10
12) Make sure the O-ring is seated in the
channel and position the clear cell rmly on the
O-ring, as shown.
11) Clamp together the 2 halves of the saddle
clamp, ensuring both clips are engaged.
15) Note: Ensure the locking ring is level
when engaging the threaded housing.
Warning: Do not over tighten the
locking ring.
16) Securely connect the cell leads to
the terminals.
11
17) Fit the cap.
18) Turn the pwer pack on.