Owner`s manual

Less than
1.5m
3) Plug it into the power point but do not
turn on yet.
4) Ensure placement of Clearwater Ei cell on
pipe is no more than 1.5m from power pack.
8
SETTING THE
CLOCK
Apply power to the Clearwater Ei unit.
Wait for the start up sequence to nish (±5 seconds).
Press and hold the button.
While holding the button, press the button to increment the
hours to the correct time.
Note: button can be held to speed up increments.
While holding the button, press the button to increment
the minutes to the correct time.
Note: button can be held to speed up increments.
Release the button - the clock is now set.
1)
2)
3)
4)
5)
6)
NOTE: The clock display is in 24 hour format
Clock
Clock
Hours
Hours
Clock
Minute
Minute
Clock
7) Invert the lower housing half of the saddle
clamp to mark the holes for drilling.
8) Drill holes using the hole saw provided
and ensure holes are clean and smooth.
13