Owner`s manual

Tools required before you begin
Before you begin installing your Clearwater Ei salt chlorinator please check you have
the right tools and a suitable location to install the Clearwater Ei unit. Please also
ensure you have read and understood the Safety and General Warnings sections, in
this manual.
An electric drill
A 6mm hammer drill bit if you need to drill into
brick or concrete
A pencil or marking pen
A screwdriver or screwdriver bit (for the drill)
A straight horizontal length of pipe on the return
line after the lter and all accessories/equipment
(the Clearwater Ei unit should be the last piece
of equipment)
A power point needs to be located no more than
1.5m away from where you mount the power pack
1)
2)
3)
4)
5)
6)
1) Screw the power pack bracket into posi-
tion ensuring it is no more than 1.5m from
a power point.
2) Position the power pack in place by aligning
the bracket with the corresponding holes.
Mounting the control unit
INSTALLATION
7
If a timer setting has been set, a small ‘T symbol will appear in the top right corner of the screen.
The Clearwater Ei unit has 2 ON/OFF timers available, which can be set to enable
the chlorinator to run up to 2 cycles each day.
From the main operating screen, press the button.
Wait for message to clear.
Press the button to increment the hours setting to the desired setting.
Note: button can be held to speed up increments.
Press the button to increment the minutes to the desired setting.
Note: button can be held to speed up increments.
Once a suitable ‘ON’ time is set, press the button to move to
setting the ‘OFF’ time. (There is a factory preset Off time of 3hrs after the On
time, simply adjust if you require more or less)
Repeat steps 3 and 4 to set the desired off time.
1)
2)
3)
4)
5)
6)
For most pools we recommend running your ltration equipment 3hrs
in the morning and 3hrs in the evening during summer, and 2hrs in the
morning and 2hrs in the evening during winter. You may need to adjust
this depending on bather load and climate conditions.
Timer
Hours
Hours
Minute
Minute
Timer
SETTING THE TIMERS
14