Operating instructions
5
ELECTRICAL HAZARD
To avoid accidental contact with lawn mowers and hedge
....................trimmers, power cords should remain within sight and above
ground at all times.
The Zodiac Ei Power pack must not come into contact with water and should
be installed at least 3 metres from the inside wall of your swimming pool.
Should a lack of water be detected, the unit’s electronic flow switch is designed
to turn off the system. Interfering with the electronic flow switch could result in
personal injury and/or damage to the cell.
One pump per electrical socket only (no ancillary equipment should be
connected to the same outlet).
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
The installation of the chlorinator should be carried out in
accordance with the Australian wiring rules AS/NZS 3000.
The chlorinator power pack should be located in the correct pool zone and
connected to supply via a power outlet that is protected by a residual current
device (RCD) having a rated residual operating current not exceeding 30mA.
The power outlet should have a degree of protection suitable for the pool zone
Ensure that equipotential bonding of all parts of the pool installation is carried
out.
1) Remove the cap and cell leads
2) Undo the locking ring. If required, use
the Ei locking ring tool provided
3) Remove the cell
CLEANING
THE CELL
18
4) Refit the cap on the cell, invert and fill
to the top of the electrode plates with the
acid solution. Leave no longer than 30min
Before you remove the cell for cleaning
ensure you shut off any necessary valves to
prevent any water loss.
WARNING wear correct safety protection
Once the cell is clean you can simply dispose of the solution by throwing it into
your pool or check with your local council regulations
PLEASE NOTE: When ever mixing water/acid always add acid to the water.
Never add water to acid. Use a mixing ratio of 10 parts water to 1 part acid
Ei Brochure A4 Spread 090701.indd 6 1/07/2009 2:27:43 PM