Operating instructions

SETTING THE
CLOCK
10
Apply power to the Ei unit
Wait for the start up sequence to finish (~5 seconds)
Press and hold the
button.
While holding the button, press the button to
increment the hours to the correct time. ( button can be held to
speed up increments)
While holding the
button, press the button to increment
the minutes to the correct time. ( button can be held to speed up
increments)
Release the button - the clock is now set.
1)
2)
3)
4)
5)
6)
NOTE: The clock display is in 24 hour format
MANUAL
OPERATION
13
USING AN
EXTERNAL TIMER
In addition to running off a timer, the Ei can also be operated manually
by pressing the button. The Ei will run until the next ‘OFF’ time is
reached, then will operate from the timers.
NOTE: If the Ei is manually turned on and no ‘OFF’ time is set, the Ei will
run for a maximum of 24hours continuously, then turn ‘OFF’ to prevent
over chlorination.
1)
2)
3)
In some cases it may be desirable to connect the Ei to an external time
switch. In this case, the chlorine output must turn on whenever power is
supplied to the power pack. To set the Ei up to run this mode, NO TIMERS
should be set.
Clear any timers that are set (a small ’T’ symbol will be visible in the top
right corner of the screen if a timer is set). See page 12 ‘CLEARING THE
TIMERS’
Turn the chlorine output on and set to the desired output level. See page
14 ‘SETTING THE OUTPUT LEVEL’
Set the external timer to the desired setting.
Ei Brochure A4 Spread 090701.indd 11 1/07/2009 2:28:20 PM