Operating instructions

9
CONTROL
PANEL
Indicates the level of
chlorine output production,
each light is 20%
production
Indicates
not enough
flow through
the cell
Indicates
salt level is
too low
SETTING THE
OUTPUT LEVEL
Turn the chlorinator ‘ON’ by pressing the button.
Press the UP button to reach the desired output level. One amber level is
the minimum setting (20%) and the output can be adjusted in increments
of 20% up to 100.
If the ‘UP’ button is pressed beyond 100%, the output level setting will
drop to 20%.
1)
2)
3)
NOTE: If your output is set at 20% (one light) the Ei will run for 2mins
every 10mins, 40% (2 lights) it will run for 4mins every 10mins and so on.
Safety Alert: if using a pool cover of any kind always reduce your
chlorine output to a minimum. High levels of chlorine in your pool
will corrode some equipment such as pool cleaners etc
CONNECTING TO AN EXTERNAL CONTROLLER
The Ei chlorine generator can be connected to an external control device such
as a Jandy Aqualink or Polaris EOS etc. please go to www.zodiac.com.au and
find further information regarding these connections.
When setting the chlorine output level you must consider the size of the pool,
the amount of use the pool will be receiving and how hot the weather is. All
these factors weigh greatly on the level of output needed. Simply adjust the
output level needed using the following steps.
14
Ei Brochure A4 Spread 090701.indd 10 1/07/2009 2:28:09 PM