User Manual

ZODIAC POOL CARE EUROPE
ZA De la Balme
31450 BELBERAUD
Zigbee Module user's manual
ZIG_MOD_100
FCC ID : RIR-24ZTM100
IC: 10837A-24ZTM100
Date : 30/07/2013
Page : 3 / 4
Confidentiel / Confidential
4. IMPACT ON HOST PRODUCT
4.1. LOCATION
The exact Gerber file should be reproduced on the host PCBA.
Module should be located in a board corner.
4.2. LABELLING
Host product needs to be marked with the following label :
Please refer to Drawing: H04218
4.3. HOST PRODUCT USER’S MANUAL
Host product user’s manual should display the following statement:
FCC Statement
This device complies with Part 15 of the FCC Rules and IC licence-exempt RSS standard. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception which
can be determined by turning the equipment off and on, the user is encouraged to try to correct interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.