Technical data

LED Indicators

Ethernet Switch Blade

Chapter 2

7 Board held in reset 1. The Shelf Manager is holding the Switch in RESET.

Follow the troubleshooting tips in "Diagnosing a failed

Shelf Manger Activation" in the Ethernet Switch Blade

Manual to extract the Shelf Manager information for

further analysis.

2. If, after troubleshooting the Shelf Manager information

the Switch is still being held in RESET, replace the

Switch.

8 Network Error 1. The EXT FLT LED indicates communications could not

be established with one or more remote partner devices

on an active port or ports. Ports which were configured

to be up (via ifconfig), but do not have remote partner

devices attached, can cause the EXT FLT LED to be lit,

even if there are no hardware problems with the

Switch. See "Network Configuration Problems" in the

Ethernet Switch Blade Manual for more information.

2. Examine the cable between the Switch and the remote

partners. If the cable is disconnected, broken, or

damaged, replace the cable.

3. Verify that the remote partners are active. If not,

activate the remote partner and verify proper

operation.

4. If the remote partners are active and the cable is good,

reset the switch by pressing the fabric reset button.

5. If the fabric reset button does not correct the problem,

replace the Switch.

Table 2-2 Solution Table for LED Indicators (Continued)

Tip Problem Solution