Technical data

LED Indicators
Ethernet Switch Blade
Chapter 2
78
Abnormal LED Activity
Use the table below as a guide to troubleshoot the LED indicators after the Ethernet Switch Blade has been
powered up in the chassis for at least 60 seconds and allowed to go through the normal boot process. Table 2-1
translates the LED indicators on the front panel of the Ethernet Switch Blade into a Tip number. Use the tip
number listed in Table 2-1 to find a solution in Table 2-2.
Table 2-1 Troubleshooting the Ethernet Switch Blade with Status Indicators
Troubleshooting with LED Status Indicators
Hot-Swap
(Blue_
Healthy
(Red /
Green)
CLK
(Green)
OK
(Green)
Int
Fault
(Amber)
System
(Green)
Out of
Service
(Red)
Ext
Fault
(Amber)
Tip
Off Green Blinking
Green
Green Off Off Off - Normal
Off Off Off Off Off Off Off Off 1
Blue or
blinking
blue
RED Off Off Off .. .. Off 2
Off Red Off Off Off .. .. Off 3
Off Green Off Off Off .. .. Off 4
Off Off Red Off Off .. .. Off 5
.. .. .. .. Amber Off OFF Off 6
.. .. .. .. .. .. Red .. 7
.. .. .. .. .. .. .. Amber 8