Technical data

Field Replaceable Unit Removal and Replacement
HP bc2100 ATCA Server Blade Hard Disk Drive
Chapter 1
67
Figure 1-21Hard Disk Drive (Arrows Point Toward the Blade Connector)
Step 6. When disconnected from the blade SAS connector, lift the HDD body with mounting brackets free of
the HP bc2100 ATCA Server Blade circuit board.
Step 7. Lay the HDD body with mounting brackets flat on an ESD-safe working surface with the
circuit-side facing upward (see Figure 1-22).
Figure 1-22Hard Disk Drive, Mounting Brackets Attached
Step 8. Remove the four counter-sunk mounting bracket screws in the side of the HDD body. There are two
screws on each side (circled in red in Figure 1-22).
Step 9. Set the mounting bracket screws and the brackets aside for reuse, and place the HDD body into an
anti-static bag.