Technical data

Field Replaceable Unit Removal and Replacement
HP bc2100 ATCA Server Blade Hard Disk Drive
Chapter 1
64
HP bc2100 ATCA Server Blade Hard Disk Drive
This section provides information on removing and replacing the HP bc2100 ATCA Server Blade optional
Hard Disk Drive and Mounting Kit.
R
emoving the Hard Disk Drive and Mounting Kit
CAUTION Electrostatic Discharge Hazard. Observe all ESD safety precautions while completing this
procedure. Failure to follow ESD safety precautions could result in damage to the 14-Slot Shelf
and equipment.
To remove the Hard Disk Drive (HDD) and Mounting Kit, complete the following steps:
Step 1. Following the blade hot-swap procedures, remove the HP bc2100 ATCA Server Blade from the shelf.
Step 2. Lay the Server Blade flat on its left side on an ESD-safe working surface, with the blade front panel
facing you (Figure 1-19). Ensure that the blade backplane connector (blue color) is facing away from
you, and located on the far right corner of the blade as it lays flat.