Technical data

Field Replaceable Unit Removal and Replacement

HP bc2100 ATCA Server Blade

Chapter 1

HP bc2100 ATCA Server Blade

The HP bc2100 ATCA Server Blade is a hot-swap FRU and can be removed and replaced while the 14-Slot

Shelf is fully operational.

WARNING Electrical Shock Hazard. System power is applied to the 14-Slot Shelf at all times during this

hot-swap removal and replacement procedure. Observe all electrical safety procedures while

working on this hot-swap unit.

Removing an HP bc2100 ATCA Server Blade

CAUTION Electrostatic Discharge Hazard. Observe all ESD safety precautions while completing this

procedure. Failure to follow ESD safety precautions could result in damage to the 14-Slot Shelf

and equipment.

To remove an HP bc2100 ATCA Server Blade, complete the following steps:

Step 1. Loosen the two retention screws on the HP bc2100 ATCA Server Blade front panel.

Step 2. Simultaneously pull both HP bc2100 ATCA Server Blade extraction levers to the one-half open

(extract) position only. The blue hot-swap LED located on the HP bc2100 ATCA Server Blade front

panel (Figure 1-6) will initially illuminate in a blinking mode. When the HP bc2100 ATCA Server

Blade can be safely removed, the blue hot-swap LED will illuminate continuously.