Technical data

Chapter 4
System Event Log Decoding
Sensor Type Codes (Table 36-3 from the IPMI v1.5 Documentation)
210
System Event 12h 00h
01h
02h
03h
04h
System Reconfigured
OEM System Boot Event
Undetermined system hardware failure
(this event would typically require system-specific
diagnostics to determine FRU / failure type)
Entry added to Auxiliary Log
(see 25.12, Get Auxiliary Log Status Command and 25.13,
Set Auxiliary Log Status Command, for more information)
Event Data 2
[7:4] - Log Entry Action
0h = entry added
1h = entry added because event did not be map to standard
IPMI event
2h = entry added along with one or more corresponding SEL
entries
3h = log cleared
4h = log disabled
5h = log enabled
all other = reserved
[3:0] - Log Type
0h = MCA Log
1h = OEM 1
2h = OEM 2
all other = reserved
PEF Action
Event Data 2
The following bits reflect the PEF Actions that are about to
be taken after the event filters have been matched. The
event is captured before the actions are taken.
[7:6] - reserved
[5] - 1b = Diagnostic Interrupt (NMI)
[4] - 1b = OEM action
[3] - 1b = power cycle
[2] - 1b = reset
[1] - 1b = power off
[0] - 1b = Alert
Table 4-5 Sensor Type Codes (Table 36-3 from the IPMI v1.5 Document)
Sensor Type
Sensor
Type
Code
Sensor
Specific
Offset
(Data 1)
Event