Technical data

Chapter 3
Diagnostics
HP bc2100 ATCA Server Blade Diagnostics Syntax and Semantics of UI
182
This switch forces testing to stop when an error occurs. When tests are stopped, a signal is sent to all running
tests. Each test is responsible to check the signal, stop testing, clean up and execute. The amount of time it
takes to stop is varies when tests are running in parallel.
/FOREVER
Command Line: /FOREVER
This switch determines the name of the summary file as specified by the filename parameter. By default, the
name is “summary.out”.
/SUMMARY
Command Line: /SUMMARY
This switch determines the name of the summary file as specified by the filename parameter. By default the
filename is ‘summary.out’.
/SF
Command Line: /SF
This switch has the same functionality as the /SUMMARY switch.
/V
Command Line: /V mask
This switch causes verbose (debug) messages from tests to be displayed.
If the optional mask parameter is -1 or 0xFFFFFFFF, all verbose messages are displayed. If the value is 0x1,
then only level 1 debug messages are displayed. If the optional mask parameter is not defined, then the
default value (-1) is used.
/PORT
Command Line: /PORT number
This switch forces executive communication sockets to use the port specified by the number parameter. The
number parameter is required.
/Q
Command Line: /Q
This switch suppresses most output to screen. It does not suppress “info” and “prompt” messages, because
these are intended to be presented to the user at all times.
/L
Command Line: /L