Technical data

Chapter 3
Diagnostics
HP bc2100 ATCA Server Blade Diagnostics Syntax and Semantics of UI
181
Command Line: /RUN
This switch causes XTC to run tests when the application starts. The tests run are those in the flow tree of the
test package specified on the command line. If the /AUTO switch is used in combination with this switch,
autoconfig runs before testing is started.
/CFG
Command Line: /CFG configname
This switch causes XTC to load a specific configuration tree when it starts. This is particularly useful when
used with the /RUN command.
The configname parameter must be the name of a configuration tree in the package file.
/PC
This switch has the same effect as the /CFG switch.
/MINUTES
Command Line: /MINUTES number
This switch forces testing to stop after a specified number of minutes.
The number parameter indicates the number of minutes the test should run. The number parameter is
required. If the parameter is omitted the command is ignored.
/LOOPS
Command Line: /LOOPS number
This switch forces testing to stop after a specified number of minutes.
The number parameter indicates the number of loops. By default testing stops after one loop.
/N
This switch has the same effect as the /LOOPS switch
/QUIT
Command Line: /QUIT
This switch forces STC to exit after tests have been run. This switch is most commonly use with the /RUN or
/AUTO switch.
/HE
Command Line: /HE