Technical data

LED Indicators
HP bc2100 ATCA Server Blade
Chapter 2
112
NOTE The LED’s error state color default to red, but the color can be overridden using PICMG
3.0-defined commands.
The default color and override capabilities of the LED follow the LED management requirements defined in
Section 3.2.5 of the PICMG 3.0 Specification. It is possible to override the default IPMC behavior of the LED
using ATCA FRU LED Control commands.
IDE Drive Activity LED
The IDE Drive Activity LED is located on the faceplate of the HP bc2100 ATCA Server Blade, as shown in
Figure 2-17.
Network Link and Speed LEDs (10, 100, 1000 Mbps Ethernet)
The front panel of the HP bc2100 ATCA Server Blade provides two LEDs for each of the four Ethernet
connections, which indicate the speed and link activity for that network connection (see Figure 2-17.
The Gigabit Ethernet (GbE) Network Link activity LEDs are identified by the following graphical legends
located on the Server Blade front panel:
Network Link activity LED states are defined as shown in Table 2-26.
Table 2-24 Health LED
LED Status Meaning
Solid Green Healthy
Solid Amber/Red Fault or error condition
Table 2-25 IDE Drive Activity LED
LED Status Meaning
Off Normal/No disk access
Green (Blinking) Disk access (read/write activity)
Table 2-26 Network Link Activity LEDs
For Channel A (L2) and Channel B (L6)
Link LED Status Meaning
Off No link
Solid Green Link Established
Blinking Green Link with activity