Installation guide

A Sample VLAN Topology
A Sample VLAN Topology
Chapter 7
94
Figure 7-12 Port IPMB Mapping
Configuring the HP bc2100 ATCA Server Blade Ethernet Interface Connectors
To connect your HP bc2100 ATCA Server Blades into the sample network topology (created earlier in this
chapter), you must configure at least some of the Ethernet interfaces included in the Server Blade. There are
six Ethernet external interface connectors on each Server Blade; eth0 through eth5. Table 7-1 provides a map
of the Server Blade.
Table 7-1 14-Slot Shelf Server Blade External Ethernet Connections
Server Blade Interface
Switch Blade
Connection
Base or Fabric
eth0 Left Switch Blade Base
eth1 Right Switch Blade Base
eth2 Left Switch Blade Fabric
eth3 Right Switch Blade Fabric
eth4 Left Switch Blade Fabric
eth5 Right Switch Blade Fabric
10Gb = 48 49 50
Fabric face = 20 21 22 23 Fabric rear = 44 45 46 47
Ba se face = 12 xx 14 15
Base rear = 16 17 18 19