Installation guide

A Sample VLAN Topology
A Sample VLAN Topology
Chapter 7
67
Figure 7-6Identifying Jumpers B141 to B144 Installed on ShMM Carrier Board
Step 3. Reinstall the ShMM Carrier Board in the 14-Slot Shelf.
The default IP address for eth0 for the ShMM is either 10.0.0.52 (active ShMM) or 10.0.0.53 (backup
ShMM). Since you are hiding the ShMMs on their own private network such that they are only known to the
Switch Blade, you will move eth0 to the 192.168.0.x network.
To move eth0 to the 192.168.0.x network, complete the following steps:
Step 1. Enter the following ShMM commands on the active ShMM:
clia setlanconfig 1 3 192.168.0.2
This command sets the IP address of the active and backup ShMMs for eth0.
clia setlanconfig 1 6 255.255.255.0
This command sets the netmask of the active and backup ShMMs for eth0.
Jumpers B141, B142,
B143, and B144