Installation guide

Rack Mounting the 14-Slot Shelf

Chapter 3

Figure 3-4M5x0.8x16, Torx Pan Screw, with Crest Cup Washer

Step 6. Using four M5x0.8x16 screws (Figure 3-4), attach the left mounting slide to the front and rear left

cabinet rails as a mirror image of the installed right mounting slide shown in Figure 3-1 on

page 27. Use a Torx drive torque wrench to tighten each screw to 36 in-pounds (4.067 N-m).

Step 7. On the right and left front cabinet rail, attach four nut-clips on each rail above the installed right

mounting slides (Figure 3-1 on page 27) that will match the mounting holes in the 14-Slot Shelf

rack mounting flanges (Figure 3-5).

Figure 3-5Front View, 14-Slot Shelf, Rack Mounting Flanges Attached

Step 8. Verify that the 14-Slot Shelf is completely unpacked and its rack mounting flanges are configured

for installation into the 4-post seismic rack (see chapter 2, Unpacking the 14-Slot Shelf).

Rack Mount

Flange

Rack Mount

Flange