Installation guide

Rack Mounting the 14-Slot Shelf

Chapter 3

Figure 3-2Nut Clip, M5x0.8

Figure 3-3Installing Nut Clip

IMPORTANT The right and left rack mounting slides will support the weight of the 14-Slot Shelf

when mounted in the rack.

Step 3. Install two nut-clips onto the rear cabinet rail in positions that correspond to those installed in step

2 on the front cabinet rail. These nut-clips will be used to attach the rear of the right mounting slide

(see note below).

Step 4. Install the four nut-clips required to attach the left mounting slide as a mirror image of the right

mounting slide (installed in steps 2 and 3).

Step 5. Using four M5x0.8x16 screws , attach the right mounting slide to the front and rear cabinet rails as

shown in Figure 3-1 on page 27. Use a Torx drive torque wrench to tighten each screw to 36

in-pounds (4.067 N-m).