Installation guide

Rack Mounting the 14-Slot Shelf

Chapter 3

Figure 3-1 Mounting Slide Attached to Cabinet Rails (Rear Hold-down Bracket in

Place)

IMPORTANT Before installing the Rack Mount Kit, ensure there will be adequate vertical space to install the

14-Slot Shelf (13U chassis height) in addition to other equipment installed.

To install the 14-Slot Shelf into the EIA Seismic rack, complete the following steps:

Step 1. Determine where the 14-Slot Shelf chassis will be installed within the seismic rack.

Step 2. Install two nut-clips (Figure 3-2 and item 4, Table 3-1) onto the front cabinet rail in the location

where the right mounting slide will be attached (Figure 3-1). Ensure proper spacing of the nut-clips

for the mounting slide attachment holes.

(not included in this release)