User manual

Click to enter motion alarm interface, as shown in gure 29:

Figure 29 Motion Alarm

Steps of setting up the motion detection are as follows:

[1]

Set the alarm channel, user can choose either one channel or all channels to set alarm;

[2]

Check

[Record]

to turn on motion detected recording;

[3] [Alarm delay]

is for user to set the alarm sound duration (Ranges from 2 – 30secs)

[4]

Check

[Alarm Out]

for alarm output

[5]

Check

[Buzzer]

to turn on buzzing sound when motion detected, Click

[Save]

to save the settings.

2.3.3.8 Hard Drive Alarm

Click to enter hard drive alarm setting interface, as shown in gure 30:

Figure 30

There are three types of HDD alarm: No Disk, HDD Error, and HDD Full. Check [ON], then warning box will