User manual
22
®
[Enable AUTO SEQ]
Choosing channel numbers from 1 to 4 and setting the tour intervals, the system will
display four channels’ video image in full screen in certain sequence, the detailed steps as following:
[1] Set the interval time. It’s the time interval between two channels’ full screen display
[2] Set channels of video tour sequencing. You can set the channel numbers as per your need.
[3] Click whether to go back to quad screen. When the check box is enabled, the system will go back to quad
screen rst and then continue sequencing after one tour of sequencing.
Click [
Save],
the setting will take effect immediately.
2.3.3.6 External Alarm
Click to enter alarm setting, as shown in gure 28:
Figure 28 External Alarm
Alarm setting steps are as follows:
[1] [Alarm In]
Choose the channel number of alarm input from all four channels, users can choose according
to their specic needs, check ON to turn on alarm input channel.
[2] [Type]
Choose the type of alarm from two options: Normally Open & Normally Close.
[3]
Check
[Alarm Out]
to set the alarm output, the device only support one channel alarm output, user can
also set the time of alarm delay ( up to 30secs)
[4] [Trigger Period]
iis for setting the alarm triggered period. Click [set] to set the alarm triggered period, user
can set the period of alarm triggered according to their specic needs.
[5] [Record Channel]
is for setting the channel of alarm triggered recording, the user can choose any channel
or all 4 channels for alarm triggered recording.
[6]
Choose the type of alarm, the device supports E-mail Alarm & Buzzer Alarm. Choose E-mail Alarm, then
emails will be sent to appointed email account when alarm is triggered. Choose Buzzer, then there will be
buzzer sound when alarm is triggered.
Click
[Save]
to save all the above settings.
2.3.3.7 Motion Detection Alarm