User manual

11
®
Figure 7 Record Setting
Choose the record types: Select all to select all the four channels, uncheck all to stop recording of four
channels. You can choose single number to lunch recording of this channel.
[Add IPC]:
Click to enter IPC management interface as gure 8 shows:
Figure 8 IP Camera Cong
Note: Please read completely through Part 2: IP Camera Introduction of this manual before adjusting
any settings on the IP Camera Cong Menu. IP Cameras must be connected to the same internet
network as the NVR before any changes can be made to the IP Camera Cong menu. Please read the
2.3.3.4 (network setting) and cong the network setting before cong the IP camera.
You can add IP cameras by manually or automatically.
[1] In order to add an IP camera manually, click on the option that reads .Add Device Manually. Input the IP
address of IP cameras and corresponding listening port, then click OK. If the IP address was input correctly, a
video image of the camera should appear on the screen.
[2] Select blank channel, and click the [search] button to enter IP search interface, now it will list all the IPs of
IP cameras searched by NVR. Click the IP you wish to add to the NVR, then click [Add], if the IP address was
input correctly, a video image of the camera should appear on the screen.
[3] Click [One Step to Add], you can add IP cameras in LAN in one step.
[4] In order to enable to auto-add IP Camera function, click [Search and Add All Devices Automatically] on the
top left corner, then the system will automatically search IP cameras which are at the same segment in LAN. If
the IP address was input correctly, a video image of the camera should appear on the screen.
[5] In order to delete an IP address out of the IP Camera Cong menu, Click the IP , and then click [Dele