User manual

®
6
In the Networking tab of the IPC Config menu, you will need to change the settings
of the camera to match your router settings:
In the IP field, type in the same IP address that appeared as the IPv4 Address on
your ipconfig results, but label the last three digits to a larger value such as 101.
In the Gateway field, type in the same numbers that appeared as the Default
Gateway in your ipconfig results.
In the Sub Mask field, type in the same numbers that appeared as the Subnet Mask
on your ipconfig results.
After adjusting all of these settings, click [Save]. The IP Address, Gateway, and Sub
Mask should update immediately after you click [Save]