User manual

4.2.3 Alarm Setting

Figure 4-14 Motion detection setting

[Protection time setting] Set the time frame during which you would like

motion detection to be active. Select the time, and click the [Save] button.

Then the time period selection will take effect.

[Motion detection switch] Enable the time frame specified. If it is unchecked,

the time frame is not active. If it is checked, the motion detection time frame will

be followed.

[Motion detection setting] After enabling the motion detection switch, the

interface will appear with grid lines. Left-clicking the box will activate motion

detection for that area and right-clicking the box will deactivate motion detection

for the area.

[Alarm action mode] Set the appropriate action to take once motion is detected.

An e-mail can be sent to the e-mail specified in the e-mail section of 4.2.2. If no

e-mail settings are configured, then an e-mail will not be sent.

[Sensitivity] The sensitivity of motion detection includes four levels: Highest,

High, Medium, and Low

[Output delay] Set the delay time of alarm linkage. The time range is limited

between 0~30.

After setting all parameters, click the [Submit] button. The settings will take

effect immediately.