User manual

5
Chapter Two: Installation
This chapter provides a general description of the device’s interfaces and connections.
It will describe how to install a hard disk drive, the buttons on the front panel, and the
connections on the back panel.
1 Package Content
After removing the DVR from its shipping box, unpack the contents on a flat surface or
immediately place it where it will be located. Please refer to the “Package Contents” to
ensure you have the entire contents.
2 Front Panel Operation
Table 1-1 4/8 Channel DVR Front Panel Description
Type
Name
Description
LED
Power
Red Power indicator. It will glow red when the DVR is on
HDD
Hard disk indicator. Glows red or blinks when HDD
is active. Off if the HDD is inactive.
IR
Remote Control operation indicator. Green blinks when
being used. Black when not being used.
Table 1-2 16 Channel DVR Front Panel Description
Type
Name
Description
Buttons
Numbers:0-9
1) Input numbers.
2) One key channel selection in preview mode.
3) One key channel selection in play mode.
Numbers:10+
/0
Used in combination with 0-9 to select channels
10-16.
LED
PWR
Red LED indicating DVR is powered on.
HDD
Red LED indicating that the hard disk drive is being
accessed. May be solid or intermittent.
IR
Green LED. Will blink to indicate the use of the remote
control in conjunction with the DVR
Main
Functions
Arrow
Buttons:
【▲】【▼】
【 】【 】
1) When in menu mode press【 】，【 】to move
the selection boxes.
2)
press【▲】，【▼】to select submenu
parameters.
OK
1. Press it to confirm operations in menu mode.
2. Press it to select record type in setting schedule.
3. Press it to change status of the current motion
detection block.
POWER
Press it to power off device.
REC
Press it to start/stop manual recording.
FN
1) Press it to switch from single camera to multi
camera view and back in preview and playback
mode.
2) Press it to enter/exit continuous selection when
setting motion detection area and schedule record.
3) Press it to set start time and end time in file search.