User manual

14
Table IV 1 PTZ Operation Description
NO.
Name
Description
①
Direction
Click the arrow icons to control the pan and tilt of PTZ.
Click the center icon to call sequence or run scanning.
Please refer to the PTZ manual for details of PTZ scanning mode.
②
Speed
Set the turning speed of PTZ camera.
③
Advanced
Click and to show/hide the advanced setting
options.
④
Focus
Click to focus-in and focus-out (it is disabled for cameras with an
automatic focus).
⑤
Iris
Click to make the image brighter or darker (it is disabled
for cameras with automatic iris adjustment).
⑥
Auxiliary
Open/close auxiliaries.
Click to open and click to close. Different functions
respond to different protocols. The auxiliaries include light,
rain brash, power, etc. Please refer to PTZ Cameras manual for
details. NOTE: Up to 2 auxiliaries are supported on DVR side.
Up to 4 auxiliaries are supported on the Web Client.
⑦
Zoom
Click to zoom in/zoom out.
⑧
Preset
1, Select the preset number in the preset window.
2, Position the camera as desired position. Save the position by clicking .
Repeat the step 1and 2 to reset the desired position.
Call preset: Select the preset number you want to call, and click on the go
to button . Clear/reset preset: Select the preset number you want to
clear/reset and click on the clear button .
⑨
Sequence
Sequence is a running route of the camera that passes through multiple
presets. Set sequence:
1. Select preset number you want to call. Click on set button .
2. Repeat step 1 and 2 to add the other presets till finishing.
Click button to end setting. Click on button to clear sequence.
⑩
Track
Track is a continuous running route of camera.
Set track:
1. Click on to start setting.
2. Move camera as the track and pattern you want it to run.
3. Click on again to finish setting. Click on to run track and
click again to stop running.
Note: Whether Track is supported or not depends on the type of PTZ.
2) Motion Detection Settings
Motion detection settings include sensitivity and area. The sensitivity includes three levels: High, Med, and
Low. Please select <Tool Bar>→<System>→<Video>→<Motion Detection> to set schedule and area settings.
With the grid displayed for both schedule and area detection settings click and drag mouse to alter the schedule
and area settings. Areas not covered by a blue box on area detection grid will be disabled for motion detection.
Front Panel Operation: The area detection grid is displayed as 16 X 12 blocks on screen. Move highlight
icon among the blocks by using [◄]、[►]buttons. Please follow these steps below to set:
1.Move highlight icon to one of the blocks you want to adjust by using [◄], [►] buttons. Press [OK] button
to adjust that blocks setting. An active motion detection block will be colored blue.
2.Press [Fn] button to open a multi-box selection grid. User the [Direction] buttons to expand grid in
desired directions. Once the grid covers the desired area press [OK] to adjust the entire grids setting.
3.Repeat steps 1 and 2 until finished.
4.Press [ESC] to exit grid.
In the Motion Detection Schedule Settings users are free to schedule motion detection capabilities being on or
off based on a grid which allows for hourly and daily customization throughout the week.
3) Mask Setting
The mask setting function can make some regions of the camera image invisible. These regions in both live
preview and playback will be masked out in black. The method to set the mask is similar to the motion
detection setting. You may click and drag to select an area to mask out. Right clicking on a masked area will remove the mask and
right clicking in a non masked area will exit the masking screen. A total of 4 masking blocks can be added to each channel.
5 Playback
*File Search