User's Manual

16-channel H.264 DVR User Manual
21
3.7.6 PTZ
Enter the “PTZ” screen from MAIN MENU →ADVANCED, as shown below:
CHANNEL: Displays the channel for the PTZ settings that will be adjusted.
PROTOCOL: Select the protocol of the corresponding brand and model. Pelco-D and
Pelco-P are supported with Pelco-D being the default.
BAUD RATE: Select the baud rate used by the PTZ Camera, with the 4 options of
1200, 2400, 4800, and 9600
DATA BIT: 5, 6, 7 and 8 are available with 8 being the default.
STOP BIT: 1 and 2 are available with 1 being the default.
VERIFY: 5 options of None/Odd/Even/Mark/Space. None is the default setting.
ADDRESS: Set the address used by the PTZ camera connected to this channel.
AUTO CRUISE: Turn ON / OFF the channel PTZ cruise function. When Auto Cruise is
enabled, the user must activated is by selecting START CRUISE in the right-click
menu.
The PROTOCOL, BUAD RATE and ADDRESS must be set correctly in order for
the PTZ to function.
3.7.7 Network Setup
Enter the “Network” screen from MAIN MENU →ADVANCED, as shown below:
TYPE: Supports STATIC, DHCP, and PPPOE addressing.
STATIC: Configure the network parameters manually
DHCP: This will allow the DVR to auto-configure the network information.
Note: It is recommended to get an IP address by using DHCP: After selecting the
DHCP mode, select Apply then restart the DVR. After restarting, the system will