Wireless IP Network Camera User’s Guide CM-I12316GY 1201-1205 ,Sangda Mansion, High Technology Park, ShenZhen, Guangdong, China Tel: 0755-3363-1636 Fax: 0755-3363-1639
SAFETY PRECAUTIONS WARNING 1. Be sure to use only the standard adapter that is specified in the specification sheet. Using any other adapter could cause fire, electrical shock, or damage to the product 2. Incorrectly connecting the power supply or replacing battery may cause explosion, fire, electric shock, or damage to the product. 3. Do not connect multiple cameras to a single adapter. Exceeding the capacity may cause abnormal heat generation or fire. 4.
PRODUCT OVERVIEW Product Overview Free yourself from long video wires and enjoy the convenience of wireless technology with this IP camera. This camera can connect to your wireless router and record straight to your computer's hard drive. The advanced, built-in chip enables features such as recording triggered by motion detection, email alerts, and remote access from popular web browsers. The 1/4” CMOS image sensor provides resolution up to 640x480 (VGA) and good image quality.
SCHEMATIC DIAGRAM 1 Mount Bracket 2 Main Body 5 Antenna 3 3 Lens 4 LEDs 1201-1205 ,Sangda Mansion, High Technology Park, ShenZhen, Guangdong, China Tel: 0755-3363-1636 Fax: 0755-3363-1639
CONNECTING CABLES RCA Cable Router PC Network Cable To connect cables 1. Connect the Network cable attached on your camera to the router. 2. Connect the power adapter to the RCA Power connector attached on your camera. Note It is also a wireless IP network camera. But you need to connect the camera to the router with the network cable first to look for the device. Then you can pull up the network cable from the router.
HOW TO INSTALL Before installation Please read the following instructions before installing your camera: You have to check whether the location (ceiling or wall) can bear five times the weight of your camera. Do not allow the cable to be caught in a pinched area, otherwise the electric line cover may be damaged. This may cause cable breakdown or fire. When installing your camera, don't allow anyone to walk or stand under your installation site, and remove all valuable items.
HOW TO INSTALL step 2 Attach the Mount Bracket to the mounting location using the 3 screws supplied in your package. As shown in the picture, push the three screws into the three holes on the Mount Bracket, then twist the screws into the mounting location using a screwdriver. step 3 Attach the Main Body of the camera to the Mount Bracket by twisting the Mount Bracket into the screws under the camera.
CAMERA SPECIFICATION Specifications for NTSC & PAL Standard Item Product type Power input Wireless Standard IP Mode Video Compression Image device Frame Rate Resolution Electronic Shutter P/T Control P/T Protocol Minimum illumination IR Lamps IR Distance Web Server Details Wireless IP Network Camera DC 12V/1A WIFI, 802.
FCC Statement This device complies with part 15of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received including interference that may cause undesired operation. Note This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of FCC Rules.
