User's Manual

31
®
Network
Settings
Network Static IP, Dynamic IP, PPPoE Static IP
IP Address No menu options, click directly into settings 192.168.0.10
Subnet Mask No menu options, click directly into settings 255.255.255.0
Gateway No menu options, click directly into settings 192.168.0.1
HTTP Port No menu options, click directly into settings 80
Media Port No menu options, click directly into settings 8000
PPPoE Setting ON/OFF; No menu options, click directly into settings OFF
PPPoE Address
No menu options, display IP address when PPPoE dial-up
successfully
0.0.0.0
DNS address No menu options, click directly into settings 202.96.134.133
Dynamic Domain
Name
No menu options, click directly into settings OFF
Email Setting No menu options, check the settings directly
Mobile Port No menu options, click directly into settings 9000
UPnP setting Click directly into sub-menu settings OFF
FTP setting Click directly into sub-menu settings OFF
Client Supported Versions:
iPhone
®
4.3 up, Android™ 2.2 up are supported; please choose the smart phone of these version.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must be co‐located for operating in
conjunction with any other antenna or transmitter.