User's Manual

The above setting is similar to Mail Server Settings，when alarming is triggered it
also sends image. Please enter FTP server、FTP port、FTP user、FTP
password, FTP upload directory、FTP mode，FTP mode has two options: PORT
and POSV. If it needs a quick image upload please select it and then select
upload image interval (second).
As shown below, there are two modes of alarm trigger. The first one is motion
detection. Please refer to the interface below. The sensitivity of motion detection
can be adjusted according to the users requirements. The higher the number is,
the lower sensitivity is. Another mode is input alarm, when connected, it triggers
alarm through alarm input signal which connects to link the alarm GPIO.
When triggered, there are 3 alarm modes：One is IO alarm linkage, camera
connects with linkage alarm box through GPIO, sound the siren ；the second is
email notification, send email with images captured；the last is upload pictures
alarm，as mentioned before-FTP picture uploads interval (second). Keep
consistent with the mentioned upload pictures interval of FTP service settings.
The schedule refers to alarm timing. As the selected time interval: 0：00 minute
per week to 0：45 minutes and Monday 1：00 hour and 2：00 hour
3.4.7 Alarm Service Settings
Figure3.17
Figure3.18
This section is for camera firmware upgrades and it includes device system
firmware and device application firmware
. Be cautious when upgrading as it could trigger
problems with settings of device.
3.4.8 Reset/Firm Ware Upgrade
18