User's Manual

Add a local area network equipment

In the multi-device configuration page, you can see all the equipment inside the

LAN. The first device is the default device. You can add more devices listed in the

list of equipment. Embedded applications, up to 4 devices at the same time. Click

“second road equipment” and double-click “Current list of devices in the LAN” in

the device entry name, host address, Http port will automatically be filled.

Requires the user to fill in the correct account name and password, click “Add.”

Repeat this process to continue to add devices. Finally do not forget to click on

the “Settings” button.

UPnP set: If you want internet access to IPCAM, ensure that the state is correct

UPnP.

Device Firmware Upgrade: The system firmware update and application thereof.

Restore factory settings : When there is not a response when the error

occurred, you can restore the factory settings to resolve the device.

I rebooted the device: Rebooted the device.

Back: Return to monitor mode

3.4.1 Multi-Device Settings

Add a device on the internet

First, make sure you want to add devices to access via IP address or domain

name. For example: http://202.96.133.134: 9008 or http://IPcam.dyndns.org:9008.

Then fill in the host address: 202.96.133.134 HttpPort: 9008 or host address:

IPcam.dyndns.org Http port: 9008. Fill in the above correct account name and

password and click “Add.” Repeat the above steps to add other devices.

Figure3.9