Owners Manual

1918
Cooktop Cooking
OPERATION
Cooktop Cooking
SURFACE BURNER OPERATION - ELECTRIC IGNITION
To activate the electric ignition, simply push the knob in to activate the spark. While
still pushing the knob in, turn the control knob counter-clockwise to release the gas.
The spark will be released at the metal tip of the white ceramic pin located on the side
of the burner. Once the flame is on, release the control knob gently. If the flame turns
off, simply repeat the above procedure.
DO NOT ignite the burners if the black burner cap is not installed or not
centered, the flame will be irregular.
MANUAL IGNITION
Manual ignition is always possible even when the power is cut off or in the event of
a power failure. Turn the control knob counter-clockwise to the MAXIMUM position;
light the flame with a kitchen lighter or with a match.
USING THE BURNERS CORRECTLY
Keep children at a safe distance from the appliance during operation. DO
NOT allow children to operate the appliance!
1. Always check that the burner caps are
properly installed before operation:
2. Verify that the flame of the worktop
burners is completely blue and with
a regular aspect as shown below:
3. Never let flames wrap around
cookware.
ZLINE cast iron griddle (only available on 48” size) comes pre-seasoned. Regularly
seasoning the griddle is recommended.
WARNING
WARNING
A
B
A
B
Correct
Incorrect
Correct Incorrect
A
B
A
B
A
B
Correct
Incorrect
Correct Incorrect
A
B
A
B
A
B
Correct
Incorrect
Correct Incorrect
A
B
Controls
OPERATION
Cooktop Cooking
Be sure to set all worktop/oven/broiler burner controls to the OFF position after each
use of the appliance.
Maximum temperature setting/recommended control knob position for burner
ignition.
The regulating knobs should be turned in anti-clockwise direction until the small flame
symbol, vice- versa for the larger flame symbol. To light up the burner, keep pushing
the knob and turn it anti-clockwise to maximum, and hold it for 3 to 5 seconds.
The ignition will spark and ignite the burner. At this position, the gas supply is at
the maximum and the flame also at its maximum. You can reduce the flame size by
turning the knob in anti-clockwise direction. Should the burner fail to light up, turn the
knob to its original position and try again. Your burner flame should be blue in colour.
NOTE: When igniting a burner, all burners will spark, but only the burner’s knob you
are using will ignite the flame.
NOTE: When first used, the gas burner will not ignite immediately. Time is required for
the LPG to fully fill the operating system.
The flame color should always be blue. Flickers of orange and yellow are
acceptable. If flames appear orange or yellow and stay that way, check the
surrounding area. Candles, cleaning products, and other changes in
atmosphere can affect the flame color.
OFF
WARNING
OFF
OFF
Maximum Flame Height
Minimum Flame Height