Owners Guide

16
INSTALLATION
Gas Conversion Procedure
STEP 3:
1. Light one burner at a time and set it to the MINIMUM position (small flame).
2. Remove the knob.
3. The range is equipped with a safety valve. Using a small-size flathead
screwdriver, locate the choke screw (see diagram below) and turn to the right or
left until the burner flame is adjusted to desired minimum.
4. Make sure that the flame does not go out when switching quickly from the
MAXIMUM to the MINIMUM position.
The high flame setting cannot be adjusted to be lower. If the height is too
high, revisit the conversion set up. A step may have been missed.
Flame
Adjustment
Video
2.0 x 50 mm
2.0 x 50 mm
Flame Adjustment
WARNING