Installation Sheet

3130

Insert Installation

Under Cabinet Installation

UNDER CABINET INSTALLATION

If you need to convert your under cabinet range hood

to rear ducting, use the following instructions. Please

note that converting the undercab to rear ducting is

a modiﬁcation of the standard hood and part of the

installation process. It is recommended that the hood is

inspected before this procedure. Only certain undercab

models allow for rear ducting. Contact us at 1-614-777-

5004 for more information on compatible models.

1. First remove the screws from the stainless steel panel.

The small screws attach the panel to the range hood

while the larger screws attach the panel to the motor.

2. Remove the panel from the hood. The motor is

attached to the panel. Do not disconnect the motor

from the panel. The image to the right shows an

example of the motor orientation.

3. Remove the blower/motor from the range hood.

Be careful not to pull and disconnect the attached

wiring.

4. Rotate the blower/motor so that the opening is

facing out the rear of the range hood.

5. Replace the panel so that the opening aligns with the

opening of the blower/motor.

6. Attach the panel to the range hood then attach the

blower/motor to the panel using the larger screws.

INSERT INSTALLATION

Installation Tutorial Video

36” 30”-36”