Installation Sheet

1110

Designer Wall Hood Installation

DESIGNER WALL HOOD INSTALLATION

Installation Tutorial Video

Please unpack your range hood when it is delivered and inspect to ensure all parts are

included.

PARTS SUPPLIED

NOTE: Wall range hoods with single motors will come with a square to 6˝ round

transition piece and will include a back draft damper. The ducting with these range

hoods is 6˝. Dual motor wall hoods will come with a square to 8˝ round transition piece

without a back draft damper. The ducting with these range hoods is 8˝ in diameter.

Use rigid ducting wherever possible. Try and minimize the use of elbows. It is

recommended to establish 15-20” of vertical airﬂow from the top of the hood before

executing a 90° turn or elbow. More elbows and longer runs create higher static

pressure. No more than two to three elbows are recommended. Use 40 feet of ductwork

max. The hood comes with a grounded three prong plug that can be plugged into a 15

amp circuit.

DESIGNER WALL HOOD INSTALLATION

A B C

E F

1. Main Hood with All Lights and

Button Banks Pre-Installed

2. Chimney

3. Transition Piece (for 6” or 8”)

4. Bafﬂe Filters

5. Flexible Duct (for 6” or 8”)

6. Packet of Screws and Anchors

7. Top Mounting Bracket

8. Crown Molding Bracket

9. Crown Molding

10. Grease Cup

30”-36”36” Height Max 36”

Scan Me