Installation Guide

15
INSTALLATION
REVERSING THE DOOR SWING OF YOUR APPLIANCE
If you want to reverse the opening direction of the door, follow the instructions below as if the
door handle is on the left side of the unit and the door swings out toward you to the right. A
second person is recommended to tilt the cooler roughly 30° to help with this task. NOTE: Do
not tilt the cooler more than 45° or lay it on its back, as that may damage the sealed cooling
system. It’s recommended to lift the appliance onto a workbench for easier access.
1. Remove the two Phillips-head screws from the axis plate at the bottom of the door to remove
the plate; set it and screws aside. Pull out the door from the top and bottom hinge brackets.
2. Take out the three screws from the bottom right hinge bracket and remove. Set the screws
aside and hold onto the bracket for future use if you wish to reverse the door swing again.
3. Remove the three screws from the upper right bracket and remove. Set the screws aside and
hold onto the bracket for potential future use.
4. Using your fingers or a thin object, remove the three black decorative tabs from the top left
of the cabinet. Push those tabs in the three holes where the bracket was removed in step 3.
5. Install the upper hinge bracket from the hardware package included with this manual at the
top left of the cabinet with the three screws removed in step 3.
6. Install the new lower hinge bracket at the bottom left of the cabinet with the three screws
removed in step 2.
7. Take the axis plate removed in step 1 and slide it onto the bottom of the door with your
hand. No screws are needed yet; push the top of the door into the top bracket and then
slide the door into the bottom bracket with the axis plate between the door and the bracket.
8. Making sure the axis plate is lined up with the bottom bracket, put in the two screws
removed from step 1. NOTE: This last step is best for two people — one person to hold the
door so the screw holes are aligned, and the other to fasten the screws.
NOTE: The door opens to a maximum of 135° with a door stop on the bottom hinge bracket
preventing the door from opening further.
Scan to follow along with a video.
Reversing the Door