Installation Guide

ManualsBrandsZLINE Kitchen and Bath ManualsAppliancesAutograph Edition Touchstone 24 in. Dual Zone 44-Bottle Wine Cooler with Glass Door and Matte Black Handle

Table Of Contents

Important Safety INFORMATION

Integrated Panel Installation

INSTALLATION

INTEGRATED DOOR PANEL INSTALLATION INSTRUCTIONS

1. Remove the door from the unit as outlined in the steps on page 12.

2. By hand, remove the rubber door seal to access the panel mounting holes. Set the seal

aside and place the door face side up on a stable surface.

3. Place the panel onto the door and align the top be ﬂush with the top of the door.

4. Adjust the overlap of the panel — panel width (23 5/8" or 600 mm) is slightly smaller

than the product (23 7/8" or 606 mm) — so it is equal on both sides of the door.

5. Secure the custom door panel to the door using 10 provided wood screws — 3 on each

side and 2 apiece at top and bottom — using a drill or screwdriver, using the precise

measurements provided on page 13.

6. Once installed, replace by hand the door seal. Be sure the seal is properly sealed.

7. Reinstall the door to the unit as outlined in the steps on page 12.

INTEGRATED DOOR PANEL DIMENSIONS

• Reference the dimensions below when fabricating your custom integrated panel.

• Figure 1 is a side view of the unit, showing how the panel (in gray) ﬁts over the panel-

ready door. A panel depth of no more than 3/4" (19 mm) is recommended.

• Figure 2 shows a front view of a custom panel; follow these precise speciﬁcations when

cutting/fabricating the panel to perfectly align with the panel-ready door.

23 5/8" (600 mm)

18 5/8" (472 mm)

Depth of unit behind door:

20 11/16" (526 mm)

Depth of door: 1 3/4" (44 mm)

Recommended depth of

integrated door panel:

3/4" (20 mm)

30"31 "

(762787 mm)

2 3/4" (70 mm)

Full product height:

34"35"

(864889 mm)

3 3/4"

(95 mm)

30" (762 mm)

6 7/8" (175 mm)

21 1/4" (539 mm)

20 1/2" (520 mm)

27" (685 mm)

Figure 1