Installation Guide
Table Of Contents
- Important Safety INFORMATION
- BEFORE Installation
- Product Specifications
- Provided Materials
- Materials Needed
- Installation
- Built-In Cabinet Instructions
- Installing The Anti-Tip System
- Reversing The Door Swing
- Integrated Door Panel Installation
- Handle Installation
- Electrical Connection
- OPERATION
- Control Panel Layout And Operation
- Error Alarms
- Energy-Saving Tips And Other Notes
- Care and Maintenance
- Troubleshooting
- Warranty
10
Cabinet Specifications
INSTALLATION
BUILTIN CABINET INSTRUCTIONS
While this unit is designed for both built-in and freestanding installation, built-in installation
is recommend to reduce risk of tipping. If you plan to use this unit in a built-in application,
please follow the cabinet cutout requirements shown below.
Depth
Height
Width
RECOMMENDED CABINET OPENING DIMENSIONS
Width
24" (610 mm)
Depth
Height 34 1/8"–35 1/8" (867–892 mm)
ADDITIONAL INSTALLATION NOTES:
• The height cut-out variance takes into account the minimum and maximum height of the
unit (34"–35"/864–889 mm) depending on the legs being at their lowest and highest
setting. Since kitchen cabinet layouts vary, consult a professional installation technician
when considering a built-in cabinet installation.
• Depth is based off standard cabinet depths of 24" (610 mm)and also allows for ample
space at the rear of the unit for the electrical cord to be plugged into a properly installed
dedicated wall outlet.
• The minimum distance the appliance should to be installed when adjacent to a wall is 11"
(280 mm). This distance is required to obtain full swing (135°) of the door.
• If using limiting pins to obtain a 90° door swing, the minimum distance the appliance
should to be installed when adjacent to a wall is 2 3/4" (70 mm); this ensures enough
room for the handle to not hit the wall.