Installation Guide

17
Trim Kit Installation
2. Remove the screws from the front bottom of your microwave. Using two of those screws,
secure the front bracket to the bottom of the microwave, ensuring the lip of the bracket is
extending down and facing you. Next, remove the screws from the back bottom of the
microwave and fasten the rear bracket, ensuring the two small lips are extended down
and facing back (see Figures 4 and 5).
Rear bracket
Front bracket
Rear bracket
Front bracket
Rear bracket
Front bracket
Rear bracket
Front bracket
Figure 4
Figure 5
3. Lay the outer trim face down and, using eight of the #2 screws, install the four buckles
on the corresponding mounting holes around the trim kit (see Figure 6). Make sure to use
the same series of mounting holes on each corner, depending on your cabinet cutout
(see Figure 7).
① 将安装好卡扣的外观框放在橱柜上作出比对；用记号笔画上安
装位置
② 用 1#螺丝将卡座安装在对应安装位置上
①
Use 2# screws to install the four buckles on the corresponding mounting
holes around the trim kit 使用 2#螺丝将四个卡扣安装在外观框四周对
应的安装孔上
Place the trim kit which install buckle on the cabinet for
contrast, then use marker strokes to draw the mounting
position
Figure 6
Figure 7
INSTALLATION TRIM KIT