Installation Guide

ManualsBrandsZLINE Kitchen and Bath ManualsAppliances24 in. 1000-Watt Built-In Microwave Drawer in Fingerprint Resistant Stainless Steel & Traditional Handle

Table Of Contents

16

Trim Kit Installation

1. Lay the support beams ﬂat on the bottom of the cabinet cutout with the open sides facing

each other (see Figure 1).

Figure 1

Rear bracket

Front bracket

Rear bracket

Front bracket

To gauge proper width, temporarily place the rear and front brackets onto the support

beams so the rear bracket lips slide into rear holes on top of the beams and the front

screw holes match to the front of the beams (see Figure 2).

Figure 2

Once aligned, secure the beams by fastening the four #1 screws with washers into the

cabinet base below (see Figure 3).

Figure 3

Rear bracket

Front bracket

Rear bracket

Front bracket

INSTALLATION TRIM KIT