Specifications

120
11.4 Caution:
1. Do not run the motor without any load.
2. The motor should not be run for more than the specifed time( prescribed by the
manufacturer)
3. Do not operate unless Jar and Dome are in proper position.
4. Do not grind hot ingredients in the Mixie.
5. Do not add solid ingredients, when the Motor is running.
6. Do not add big ice pieces while making cold drinks. Crush the ice and put into the
blender.
Note: Before using Mixie, read the opeation manual given by the manufacturer thoroughly.
11.5 Cleaning:
Body and Top Cap: Clean body and Top Cap with a damp cloth and wipe dry. Do not use
abrasives or water for cleaning.
Stainless Steel Jars and Blades: Fill in ½ litre of lukewarm water and a teaspoon of any
mild cleaning power. Run the unit on speed 1 for 30 Seconds. Rinse and dry. Always store Jars
in inverted position, to allow water to drian off.
11.6 Repairs and Remedies:
1.
Sl.No. Fault Possible Reason Remedy
Motor is not running 1. No voltage or Low voltage
2. Either motor field or
armature coil may get open
circuited.
1. Check the supply voltage with
multimeter.
2. Do the continuity test. If there is
an open circuit fault, do the service.
Supply voltage is
correct. But motor is
not running.
2. Overload in the jar and
hence overload protector
may get tripped
Press the overload relief button and
remove some materials in the jar.
Now restart.
3. Motor rotates at
same speed in all
speed settings
May be loose connections
in the regulator
Check and solder the wires at
regulator terminals.
4. Excessive heat
produced
1. May be any short circuit
in armature or field coils.
2. There may be wear and
tear in the bearings.
1. Do the continuity test. If there is
an short circuit fault, do the service.
2. Check and put lubricating oil at
bearings. If heat persists, replace
it.