Installation Guide

3
Method 2: Mounting inside the wall
STEP 1
Place the mounting sticker
to the place where device
needs to be installed
STEP 2
Drill fixing holes and dig mounting
groove deep of 36mm
10
11
Instruction for the Mounting Paper
Before the device is fastened, please
stick the paper to the place where you
want to install it, then make holes and
lay cables according to the mounting
paper.
Fixing Hole
Fixing Hole
Mountin g Paper
(only for y our refer ence)
The d epth of t he inst allat ion
gro ove is 36 mm
wall
3
6m
m
STEP 3 STEP 4
If cables need to be laid from
behind then it must be done
before installing
Install the device with the screws
After installing the back plate attach the machine part in the
same reverse manner as shown in previous page
STEP 5
BLACK
GND
12V
GND
485+
485-
PURPLE
YELLOW
BLACK
RED