Installation Guide
Table Of Contents
- What’s in the Box
- Optional accessories
- Safety Precautions
- Product PIN Diagram
- Installation of Panel & Metal Case
- Product Dimension
- Installation of Panel & Metal Case
- Wire Legend
- Power wiring diagram
- Ethernet Connection
- RS485 Connection
- Restore factory setting
- DIP Switch Setting
- Troubleshooting
- PC 485 Setting Table
- Electrical Specifications
- Specifications
37
inBIO-Series Access Control Panels & ZKAccess 5.2 software INSTALLATION GUIDE
2. Personnel No.: By default, the length can not exceed 9 digits A number with a
length of less than 9 digits will be preceded with 0 automatically to complete
9 digits. Numbers can not be duplicated.
3. Card number: You can add a card number through manual entry or a card issuer.
In Actual Card Number mode (by default), you must enter both the actual card
number and the site code, then the software converts the numbers to the
internal card number for access control system verication. In Internal Card
Number mode, enter the numbers directly.
4. Password: Set personnel password to use on a keypad reader. Password must
be 4 to 6 numbers long.
5. Department: Select from the pull-down menu and click OK . If the department
was not set previously, you can only select the default Company Name department.
6. Register Fingerprint: Enroll the Personnel Fingerprint or Duress Fingerprint.
If the person presses the Duress Fingerprint, it will trigger the alarm and send
the signal to the system.
7. Access Level: Click the box next to the access level you would like to add the
personnel to. (Optional)