Installation Guide

+
+
+
BUTTON BUTTONREADER 1 READER 2BUTTON BUTTONREADER 1 READER 2
TX RX
TX
ACT LINK
RX
POWER
RUN CARD
AUX 1
IN GND IN GND IN GND IN GND +12V GND 485- 485+
AUX 2 AUX 3 AUX 4 EXT EXT
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
NO COM NC
485+ 485-- GND
PC
AUXOUT1
NO COM NC
AUXOUT2
NO COM NC
AUXOUT3
NO COM NC V+ V- 12V GND
AUXOUT4
SEN GND NO COM NC
LOCK1
SEN GND NO COM NC
LOCK2
SEN GND NO COM NC
LOCK3
SEN GND NO COM NC
LOCK4 LOCK POWER
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
12345678
ON
#63 inBIO-Panel
=
23
inBIO-Series Access Control Panels & ZKAccess 5.2 software INSTALLATION GUIDE
DIP Switch Setting
12345678
ON
12345678
ON
12345678
ON
RS485 Address
1. Number 1-6 are reserved to set the device number for RS485 communica-
tion. The code is binary, and the numbering starts from left to right. When the
switch is set to ON position, it indicates 1 (on); when the switch is set down-
wards, it indicates 0 (o ). For example, to set a device number 39=1+2+4+32,
which corresponds to the binary code 111001, put number 1, 2, 3, and 6 to ON
position, as illustrated below.
For more details, please check the table at the end of this document.
Terminal Resistance
1. Number 8 is for setting the RS485 termination resistance. Putting the switch
to ON position is equivalent to parallel connection of a 120 ohm termination
resistance between 485+ and 485- lines.
12345678
ON
120 ohm
Figure 34
Figure 35