Installation Guide
Table Of Contents
- What’s in the Box
- Optional accessories
- Safety Precautions
- Product PIN Diagram
- Installation of Panel & Metal Case
- Product Dimension
- Installation of Panel & Metal Case
- Wire Legend
- Power wiring diagram
- Ethernet Connection
- RS485 Connection
- Restore factory setting
- DIP Switch Setting
- Troubleshooting
- PC 485 Setting Table
- Electrical Specifications
- Specifications
12345678
12345678
O
N
22
inBIO-Series Access Control Panels & ZKAccess 5.2 software INSTALLATION GUIDE
RS485 Connection
12345678
ON
12345678
ON
12345678
ON
12345678
ON
1
2
4
8
16
32
Restore Factory Setting
RS485 Terminal Resistance
Restore factory setting
1. If you forget the IP address of the inBIO panel or the device does not work nor-
mally, you can use the number 7 DIP switch to restore inBIO-Panel to factory
default settings. The parameters which gets reset are device IP address,
communication password, gateway, and subnet mask.
2. The switch is OFF by default. When it is moved up and down for three times
within 10 seconds and nally returned to OFF position, the factory settings will
be restored after the access control panel is restarted.
OFF OFF
ON
To reset factory settings
Turn #7 switch ON and OFF
Repeat process 3 times
Figure 32
Figure 33