Installation Guide

17
inBIO-Series Access Control Panels & ZKAccess 5.2 software INSTALLATION GUIDE
MA
Model Number inBIO 460
5 4 3 2 1 5 4 3 2 1 5 4 3 2 1
+
+
+
BUTTON BUTTONREADER 1 READER 2BUTTON BUTTONREADER 1 READER 2
TX RX
TX
ACT LINK
RX
POWER
RUN CARD
AUX 1
IN GND IN GND IN GND IN GND +12V GND 485- 485+
AUX 2 AUX 3 AUX 4 EXT EXT
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
NO COM NC 485+ 485-- GND
PC AUXOUT1
NO COM NC
AUXOUT2
NO COM NC
AUXOUT3
NO COM NC V+ V- 12V GND
AUXOUT4
SEN GND NO COM NC
LOCK1
SEN GND NO COM NC
LOCK2
SEN GND NO COM NC
LOCK3
SEN GND NO COM NC
LOCK4 LOCK POWER
IN GND BEEP GLED WD1 WD0 GND +12V
BUTTON READER
12345678
ON
Switching Dry Contact to Wet Contact
Important Notes:
The factory default jumper setting is set as dry mode. If you want to power the
lock from the panel, you must take the following steps:
1. Take apart the cover of inBIO Panel. Push the tab inward (see gure 21)
2. Select the appropriate lock relay and nd its jumpers
3. Take o the jumpers and change
1 2 3 4 5
to
1 2 3 4 5
4. Connect the lock as show in the diagram, (see gure 23 and 24)
Back of inBIO-Panel Select one Relay
Default setting
1, 2 - 3, 4
Take o jumpers Jumpers Plug Jumpers
2, 3 - 4, 5
Figure 22
Figure 21
MA
Model Number inBIO 460