User Manual

6
SBTL8000 series User Manual
Figure 2-2
2.3 Cables installation and fixing
For the outlets of the concealed cables, please refer to the drawing indicating the mounting holes.
The input voltage for this swing turnstile is AC110-220V, and its master and slave are connected with
an 8-core cable (signal) and a 2-core cable (power). When installing the speed gates turnstile, the
user only needs to connect it to the corresponding ports. Note that the PVC conduits are laid 100mm
under the ground, with the height of the exposed part not exceeding 100mm. In addition, the
conduit outlet is bent to prevent the ingress of water into the conduit.
SBTL 8000 series installation holes and cabling positions are as shown in Figure 2-3a: